Loading... Please wait...Sorry but this item is currently unavailable.
Please check back at a later stage.
| Mfr Part Number: ATX-300PA-B204 |
| Feature: |
| Complied with ATX12V 2.0 standard |
| High efficiency, low noise and ripple and reliability |
| Remote On/Off function |
| Internal 80mm 12V DC fan included |
| Noise Killer (Thermal fan speed control function) |
| Complies with FCC part 15 subpart J Class B and CISPR 22 Class B |
| Output over voltage, short circuit, and over current protection |
| 100% Hi-pot, ATE, and burn-in tested |
| Re-settable power shut down |
| Approved by UL 60950, TUV, IEC 60950, NEMKO (CB Report) |
| Included On/Off Switch |
| Input: |
| Input Range: +/-10% of 115Vrms/57- 63Hz, +/-10% of 230Vrms/47- 53Hz, manual selection. |
| Input Current: 7A (RMS) at 115Vrms/60Hz, 4A (RMS) at 230Vrms/50Hz |
| Inrush Current: 80A Max cold start, 100A Max warm start measured at 115Vrms/60Hz |
| Output: |
| Total Output: 300W |
| +3.3V and +5V total output not exceed 120W |
| +3.3V is load on 20A then +5V maximum load is 10.8A +5V is load on 20A then +3.3V maximum load is 6A |
| +12V1+12V2 total output not exceed 264W |
| +3.3V, +5V, +12V1, and +12V2 total output not exceed 286W |
| Connectors: 20/24pin Main power, 4pin P4 power, 4x Peripheral, 1x SATA, 1x Floppy |
| Dielectric Withstand: Input to frame ground 1800V AC for 1 second |
| Insulation Resistance: 20 Meg. Ohm Min. |
| Efficiency: 70% minimum measured at nominal AC main voltage with maximum load on all outputs |
| Rise Time: Less than 20mS on all outputs |
| Hold-up Time: 12ms minimum at 115V/230VAC |
| Power Good Signal: Power on delay time 100 ms to 500 ms, off delay 1ms minimum (TTL and CMOS compatible) |
| Leakage Current: Not exceed 3.5mA |
| MTBF:100,000 hours on maximum load at +25C |
| Dimension (WxLxH): 6 x 5.5 x 3.4 inch / 150 x 140 x 86 mm |